Engineering-first robotics, AI, maker hardware, STEM, and creator technology reporting
STEM Lab covers STEM education, youth robotics, classroom technology, competitions, learning tools, and engineering literacy, with attention to safety, cost, reliability, and real-world teaching constraints.
LSM6DSOX FIFO watermarks should leave enough headroom for interrupt latency and bus drain time. Size the batch from the active sensor rates, then watch overrun status.
LSM6DSOX FIFO Overruns: Set the Watermark From Your Drain Time Read More
INA260 averaging reduces noise but multiplies the time before a current, voltage or power alert can react. Calculate the conversion window before debugging firmware.
INA260 Alert Arrives Late? Calculate the Averaging Delay Read More
Repeatable TCS34725 readings depend on fixed illumination, sensor geometry, gain and integration time—not just converting raw channels to an RGB color.
TCS34725 Color Readings Drift? Control Gain, Exposure and Illumination Read More
A reliable NAU7802 setup treats gain, sample rate and calibration as linked controls, then checks CALS and CAL_ERR before using load-cell readings.
NAU7802 Load-Cell Setup: Calibrate After Gain and Rate Changes Read More
The SHT31’s internal heater is a plausibility-check tool, not a condensation cure or normal measurement mode. Use commands 0x306D and 0x3066 with status bit 13 and label heated samples invalid.
SHT31 Heater Checks: Prove Sensor Response Without Treating Heat as Humidity Data Read More
A robust BME280 forced-mode loop starts one conversion, waits for the status register’s measuring bit to clear, then reads the compensated result. Fixed delays hide oversampling-dependent timing.
BME280 Forced Mode: Wait for Conversion Instead of Reading on a Guess Read More
APDS9960 gesture events can repeat or disappear when firmware clears the interrupt without consuming the gesture FIFO. Read status, drain valid datasets, then finish the engine sequence.
APDS9960 Gesture Interrupts: Drain the FIFO Before Clearing the Event Read More
AS5600 angle problems often start with magnet geometry, not software noise: check detection, too-weak and too-strong status before filtering 12-bit readings.
AS5600 Angle Jumps? Check Magnet Status Before Filtering the Data Read More
ADXL345 tap detection uses scaled threshold, duration, latency and window registers plus axis enables and interrupt mapping; raw register values are not g or milliseconds.
ADXL345 Tap Detection: Convert Threshold and Timing Registers First Read More
The TSL2591 can span very dim to bright scenes, but gain and 100–600 ms integration time determine whether its full-spectrum or infrared channel saturates.
TSL2591 Saturation: Lower Gain Before Trusting the Lux Reading Read More